Alispilar

Column formwork systems to be used by hand and with a crane. The design of the panel incorporates the quick assembly by reduction system, from what only a hammer tap is needed to assemble and disassemble one column. Both systems are light weighted, do not rust, do not dent and do not get out-off-square.

- Alupilar is formed by a frame reinforced with duralumin (structural aluminium) painted with white epoxy and a 12 mm thick phenolic plywood lining that provides a good concrete finish.
- Alispilar is formed by a frame reinforced with steel painted with red epoxy and a 12 mm thick phenolic plywood lining that provides a good concrete finish.

ALUPILAR SYSTEM TECHNICAL CHARACTERISTICS
- Panel 70 measurements: 280 x 70 cm, 130 x 70 cm and 80 x 70 cm
- Panel 50 measurements: 280 x 50 cm, 130 x 50 cm
- Panel 70 allows the implementation of columns from 25 to 60 cm (in 5 cm intervals)
- Panel 50 allows the implementation of columns from 20 to 40 cm (in 5 cm intervals)
- Allowable pressure: 8000 Kg /m2 (80 KN/m2)
- Weight: 20 kg/ m2

ALISPILAR SYSTEM TECHNICAL CHARACTERISTICS
- Panel 68 measurements: 300 x 68 cm, 140 x 68 cm and 80 x 68 cm
- Panel 50 measurements: 300 x 50 cm, 140 x 50 cm and 0,80 x 50 cm
- Panel 68 allows the implementation of columns from 25 to 60 cm (in 5 cm intervals)
- Panel 50 allows the implementation of columns from 20 to 40 cm (in 5 cm intervals)
- Extensions of the 10 Panel: 300 x 10, 140 x 10 and 80 x 10 cm
- Allowable pressure: 8000 Kg /m2 (80 KN/m2)
- Weight: 30 kg/ m2

ADVANTAGES OF THE SYSTEM
QUICK
- There is no need of any additional element to assemble a four panels column.
- The weight allows handling the panels without using a crane.

FINISH
- Good column finish because of the phenolic plywood lining.
- It incorporates the PVC chamfer strip accessory for the edges finishing.

COST-EFFECTIVE
- High performance on site due to its quickness and finishing.
- Panels can be combined vertically (on height) and in horizontal reduction or cantilevered.